« previous next »
Pages: [1]   Go Down

Author Topic: CAP question: How do I make a logo fit on one side of a shirt?  (Read 1969 times)

Leto85

  • Guest
CAP question: How do I make a logo fit on one side of a shirt?
« on: October 30, 2011, 06:38:16 AM »
I wasn't sure about where to put this question, as I've never had to ask about this program before, so I think this place should be good.

The problem is: I've made a logo that I wanted to put on a sims shirt, but now it appears on both sides: front and back, while I only want it to appear on the front. Can I change this somehow?
Logged

Offline Ausette

  • Watcher
  • ******
  • Posts: 1762
Re: CAP question: How do I make a logo fit on one side of a shirt?
« Reply #1 on: October 31, 2011, 12:15:05 AM »
Not without using CC programs, I'm afraid. It's just how the pattern is applied. You never see both sides of the shirt at once, so it generally looks good anyway.  :)
Logged


Registered members do not see ads on this Forum. Register here.

Leto85

  • Guest
Re: CAP question: How do I make a logo fit on one side of a shirt?
« Reply #2 on: October 31, 2011, 04:43:15 AM »
Quote from: Ausette on October 31, 2011, 12:15:05 AM
Not without using CC programs, I'm afraid. It's just how the pattern is applied. You never see both sides of the shirt at once, so it generally looks good anyway.  :)

Ah well, that's too bad than.
I remember myself from 1.5 years ago when I've tried to attach a logo on a car. It seems that that one also got mirrored on the other side. :(
But after checking on of the UPC cars (the maid I thought) I saw that logo was also mirrored on the other side so perhaps that's just how it needed to be.
Logged
Pages: [1]   Go Up
« previous next »
 

anything